Why Everyone is Swapping Out Those Old bathroom Heat Lamps
You know those old-school bathroom heat lamps? The ones with the big bulbs that try to warm up the whole room? They’re okay, but there’s a problem. They spend all their energy heating the air, and since bathrooms have vents, that warmth just disappears into the ceiling. You’re left shivering while your electricity bill climbs. That’s why we’re seeing a big move toward Mirror infrared heaters. They work differently. Instead of fighting the air, they send heat straight to you and the surfaces around you. It’s like stepping into a beam of sunlight on a cold morning. The secret is in the mirror. If you just have a heating element, half the warmth goes up. Wasteful, right? We use parabolic mirrors to bounce all that energy back down. It focuses the heat exactly where you’re standing. The best part? Because the heat is so focused, we can actually lower the wattage. You get the same cozy feeling without pulling as much power. Dealing with the steam Bathrooms are brutal on electronics. Between the steam and the occasional splash, most circuits just give up. They corrode or short out. That’s where those “IP ratings” come in. Basically, we seal the guts of the heater—the wiring and the elements—so moisture can’t get inside. If you buy a cheap unit with a low rating, it’ll probably burn out in a single season. Not exactly a great investment. A few things to keep in mind The biggest perk here is the speed. Short-wave infrared is instant. No waiting around for the room to “warm up”—you feel it the second you flip the switch. But, there is a catch. Since the heat is so concentrated, it can get too hot if the unit is mounted too low. You don’t want a “hot spot” right on your shoulder. You’ll want to double-check your ceiling height and wattage before you bolt it in. We designed these to fit right into the spots where your old lamps used to be. Just a heads-up: make sure your circuit breaker can handle the infrared array before you start wiring. Better safe than sorry.